Use Brake Charger/Bleeder Unit - VAS5234- to extract brake
fluid from brake fluid reservoir.
. Install the Brake Pedal Actuator - VAG1869/2- to relieve pressure
before removing a brake caliper or disconnecting a brake
hose.
1 - Brake Shield
2 - TORX Screw 12 Nm
3 - Brake Rotor. Do not use excessive force to separate the brake rotor from the wheel hub. If necessary, use rust penetrant, otherwise the brake rotors could be damaged.
. Replace both sides if worn.
. To remove, first remove brake caliper and carrier
4 TORX Screw 8 Nm
5 - Brake Caliper
. Do not remove the brake hose when changing the brake pads.
6 - Internal Multi-Point Bolt . 90 Nm +90°
Remove and install using Multipoint Socket - T10035
. Replace after removing
7 - Brake Carrier
8 - Spring
9 - Outer Brake Pad
.Thickness 11 mm without backing plate
.Wear limit: 2 mm without backing plate
.Always replace on both axles.
10 - Inner Brake Pad
❑ With spring
❑ Thickness 11 mm without backing plate
❑ Wear limit: 2 mm without backing plate
❑ Check the thickness. Refer to ⇒ Maintenance ; Booklet 36.1 .
❑ Always replace on both axles.
11 - Spring
❑ Installed on the inner brake pad only.
❑ Pay attention to the installed position.
12 - Brake Line 14 Nm
13 - Bracket
14 - Brake Hose Spring on the Bracket
15 - Brake Hose with Ring Connection and Banjo Fitting
❑ To the brake caliper: 35 Nm
❑ To the brake line: 14 Nm
16 - Guide Pins
❑ 35 Nm
17 - Caps
❑ For guide pins
18 - Seal
❑ For the parking brake motor
❑ Replace
19 - Hex Socket Head Bolt
❑ 8 Nm